Edge Rewrite
restyle Source code View original
// HTMLRewriter · presentation

This page was redesigned at the edge.

Cloudflare fetched the original article and streamed it through HTMLRewriter to apply an entirely new visual system without rebuilding the source page.

Jump to content

Template:MYSint/doc

Add links
From Wikipedia, the free encyclopedia

This template creates an entry in an MOS:RJL-compliant road junction list for a Malaysian road article, regardless of jurisdiction. It is a sister template to {{Jctint}} and is directly derived from {{Jctint/core}}.

Blank template

[edit]

Single entry in the list

[edit]

This is a typical entry for an expressway, or roads with numbered and named exits.

{{MYSint|exit|name|state=|sspan=|district=|dspan=|location=|lspan=|km=|km2=|km_ref=|type=|exit=|name=|road=|notes=}}

This is a typical entry for roads with named exits or locations but unnumbered exit.

{{MYSint||name|state=|sspan=|district=|dspan=|location=|lspan=|km=|km2=|km_ref=|type=|name=|road=|notes=}}

This is a typical entry for roads without numbered or named exits.

{{MYSint|state=|sspan=|district=|dspan=|location=|lspan=|km=|km2=|km_ref=|type=|road=|notes=}}

In Sabah and Sarawak, there are named but unnumbered intersections on some roads, in which case this can be used (note that the first parameter is empty).

{{MYSint||name|division=|divspan=|district=|dspan=|location=|lspan=|km=|km2=|km_ref=|type=|name=|road=|notes=}}

If a road is entirely within a single state/territory/division and/or a single district, feel free to omit the respective parameters.

To mark a notable or significant bridge, tunnel, layby, service area, toll plaza (the latter three are all notable) or other feature that isn't an exit, replace the |exit=, |name=, |road= and |notes= parameters with |place=, for example:

{{MYSint|exit|name|state=|sspan=|district=|dspan=|location=|lspan=|km=|km2=|km_ref=|type=|place=}}

For "through to another road" or international borders roads, replace the |exit=, |name=, |road= and |notes= parameters with |place=, for example:

{{MYSint|exit|name|state=|sspan=|district=|dspan=|location=|lspan=|km=|km2=|km_ref=|type=[concur/trans]|place=Through to another road}}

Notes: concur used for the roads with same number (e g FT1 and AH2), trans used for the roads with different number or unsigned roads.

Icons should not be used for such an entry: they would be considered excessive per MOS:ICONS and MOS:ACCESS. The only icons that should be used are for route markers just before a road name.

Here's every parameter supported by the template. Drop parameters that are unnecessary.

{{MYSint|[exit/old]|name|[state/territory/division]=|[sspan/tspan/divspan]=|district=|district_special=|dspan=|location=|lspan=|km=|km2=|km_ref=|kspan=|type=[trans/concur/closed/incomplete/unbuilt/toll/etc/hov]|place=|pspan=|old=|ospan=|exit=|espan=|name=|namespan=|road=|rspan=|notes=|nspan=}}

Complete table syntax

[edit]
{{MYSinttop|[exit/old]|name|region_col=yes|region_type=[state/territory/division]|district_col=yes|location_ref=|km_ref=|old_ref=|exit_ref=|name_ref=|dest_ref=|notes_ref=|length=}}
{{MYSint|[exit/old]|name|[state/territory/division]=|[sspan/tspan/divspan]=|district=|district_special=|dspan=|location=|lspan=|km=|km2=|km_ref=|kspan=|type=[trans/concur/closed/incomplete/unbuilt/toll/etc/hov]|place=|pspan=|old=|ospan=|exit=|espan=|name=|namespan=|road=|rspan=|notes=|nspan=}}
{{Jctbtm|col=[total number of columns]|key=[trans/concur/closed/incomplete/unbuilt/toll/etc/hov],...}}

With the correct parameters this will generate a complete, MOS:RJL-compliant junction list.

Parameters

[edit]

See also

[edit]
Retrieved from "https://en.wikipedia.org/w/index.php?title=Template:MYSint/doc&oldid=1356840952"