Obturating ring
An obturating ring is a ring of relatively soft material designed to obturate under pressure to form a seal. Obturating rings are often found in artillery and other ballistics applications, and similar devices are also used in other applications such as plumbing, like the olive in a compression fitting. The term "O-ring" is sometimes used to describe this kind of pressure seal.
Ballistics uses
[edit]
Obturating rings are common in artillery, where the steel or cast-iron casing of the shell is too hard to practically deform to provide a tight seal for the propellant gases. An obturating ring which is called driving band made of a softer material is the standard solution for that problem. Mortar bombs also use obturating rings to provide a seal around the projectile. [citation needed] Recoilless rifles and some artillery use rings with a reverse impression of the rifling cut in them for a tighter seal even at very low pressures.[clarification needed]
Another obturating ring may be used on sliding/falling breech-blocks from the opposite side of the chamber to provide a tight seal there if the charge is bagged and lacks a case (examples include early Krupp guns to Royal Ordnance L11 to M777). The obturating ring provides the sealing that would normally be provided by a cartridge case.
See also
[edit]References
[edit]- ↑ "12 inch Mk X Gun Breech Mechanism : HMAS Australia (I)". Australian War Memorial. Archived from the original on 2025-08-26. Retrieved 2025-08-26.
The mechanism consists of the breech, and an interrupted screw breech block on a hinged mounting. [...] The Welin breech block was invented by Axel Welin in 1889 or 1890.
- 81 mm mortar shell information, showing the obturating ring