Edge Rewrite
// HTMLRewriter · presentation

This page was redesigned at the edge.

Cloudflare fetched the original article and streamed it through HTMLRewriter to apply an entirely new visual system without rebuilding the source page.

// request.cf · coarse context

A page that knows where it met you.

Only coarse request metadata is shown. This demo does not display or persist visitor IP addresses.

Country
US
Cloudflare location
CMH
Connection
HTTP/2
Language
Not provided

Ray ID: a21b4ec1ee97aea1

Jump to content

// Workers AI · dad joke modeWhat did the common building block say? I'm a brick above the rest.

From Wikipedia, the free encyclopedia
Common Building Block
DeveloperIntel Corporation
TypeLaptop platform
Released2005
SuccessorUltrabook specification

Common Building Block (CBB) was a set of technical standards for laptop components introduced by Intel in 2005, and adopted by some manufacturers, including Asus, Compal, and Quanta.

Creation

[edit]

In 2004, the Common Building Block program promoted the use of industry-accepted mechanical and electrical specifications for three notebook components: 14.1-inch, 15-inch, and 15.4-inch liquid crystal displays (LCDs); 9.5mm and 12.7mm optical disc drives (ODDs); and 2.5-inch hard disk drives (HDDs). The program consisted of:

  • A Web site to provide a centralized repository of information about the program, participants, and platform and ingredient specifications
  • A continually updated list of CBB-compliant ingredients (submitted by suppliers)
  • A testing and verification service for candidate products

The defunct repository site mobileformfactors.org was established to standardize components, and included:

Hard drives

[edit]

Only the 2.5 inch hard drive is a component used by CBB and its design guide does not address the integration of 1.8 inch hard drives.[1]

A notebook should support 2.5 inch SATA or PATA HDDs that are designed based on the SFF Committee Specifications, The target CBB thickness for 2.5 inch HDDs in 2006 was 9.5mm with a tolerance of +/-0.2mm, as that was the form factor most used.[1]

The HDD could be mounted with side or bottom mounting, a hard drive should comply with both, but the system could choose whichever was best suited for the application.[1]

The electrical interface for SATA HDDs should follow the electrical interface standards set by the Serial ATA International Organization (SATA-IO). For PATA HDDs they should support the specifications defined by the T13 Committee.[1]

References

[edit]
  1. 1 2 3 4 "Common Building Block (CBB) Hard Disk Drive for Notebooks" (PDF). www.mobileformfactors.org. Archived from the original (PDF) on 2007-11-09. Retrieved 2025-11-18.