Edge Rewrite
// HTMLRewriter · presentation

This page was redesigned at the edge.

Cloudflare fetched the original article and streamed it through HTMLRewriter to apply an entirely new visual system without rebuilding the source page.

// request.cf · coarse context

A page that knows where it met you.

Only coarse request metadata is shown. This demo does not display or persist visitor IP addresses.

Country
US
Cloudflare location
CMH
Connection
HTTP/2
Language
Not provided

Ray ID: a21ff930a9c23014

Jump to content

// Workers AI · dad joke modeWhy did the runway end identifier light go to therapy? It had a burning issue.

From Wikipedia, the free encyclopedia
(Redirected from REIL)
Runway end identifier lights
REIL installed near the runway 19 threshold at Teterboro Airport as seen from an approaching aircraft

Runway end identifier lights (REIL[1]) (ICAO identifies these as Runway Threshold Identification Lights) are installed at many airports to provide rapid and positive identification of the approach end of a particular runway. The system consists of a pair of synchronized flashing lights located laterally on each side of the runway threshold. REILs may be either omnidirectional or unidirectional facing the approach area.[2] They are effective for:[2]

  • Identification of a runway surrounded by a preponderance of other lighting
  • Identification of a runway which lacks contrast with surrounding terrain
  • Identification of a runway during reduced visibility

The International Civil Aviation Organization (ICAO) recommends that:[3]

  • Runway threshold identification lights should be installed:
    • at the threshold of a non-precision approach runway when additional threshold conspicuity is necessary or where it is not practicable to provide other approach lighting aids; and
    • where a runway threshold is permanently displaced from the runway extremity or temporarily displaced from the normal position and additional threshold conspicuity is necessary.
  • Runway threshold identification lights shall be located symmetrically about the runway centre line, in line with the threshold and approximately 10 meters outside each line of runway edge lights.
  • Runway threshold identification lights should be flashing white lights with a flash frequency between 60 and 120 per minute.
  • The lights shall be visible only in the direction of approach to the runway.

References

[edit]
  1. "Order JO 7340.1Z: Contractions" (PDF). Federal Aviation Administration. March 15, 2007.
  2. 1 2 FAA Aeronautical Information Manual, Chapter 2 (Aeronautical Lighting and Other Airport Visual Aids), Section 1 (Airport Lighting Aids) Archived 2009-09-04 at the Wayback Machine
  3. "Aerodrome Design and Operations" (PDF) (3 ed.). July 1999. Archived from the original (PDF) on 2012-07-23. §5.3.8, "Runway threshold identification lights"
[edit]